Skyrainbow RVS wandplank 120 × 40 cm – THWBS1R124S

Safety Instructions

WARNING – Risk of Shelf Falling: Improper installation or overloading can cause the wall shelf and its contents to fall. Serious injuries may result.

Installation

• Installation should only be performed by persons with the necessary technical skills; if in doubt, consult a qualified professional.
• Before installation, check all parts for completeness, deformation, and shipping damage. Do not use damaged parts.
• Wear protective gloves: Sheet metal edges and punched holes may be sharp (risk of cuts).
• Mounting hardware is not included. Select anchors and screws appropriate for the substrate (concrete, solid brick, perforated brick, drywall) and follow the manufacturer’s instructions for the anchors.
• The wall must be able to safely support the weight of the unit itself plus a 25 kg load. Use only suitable cavity wall anchors or a subframe for drywall and lightweight walls.
• Before drilling, check the routing of utility lines (electricity, gas, water) using a line detector.
• Position the wall rails vertically and at the same height; level the shelf using a spirit level. Use all designated drill holes.
• Screw the shelf to the brackets using the included screws so that it cannot be lifted or slid out of the brackets.
• For a width of 1800 mm, the span is large: If 3 wall rails/brackets are included, use all of them. If only 2 are included, check for deflection and stability carefully after installation.
• Two people should perform the installation; the 1.8-meter-long shelf is unwieldy.
• Do not install above heat sources (stove, deep fryer, grill) where rising heat could endanger stored items or plastic containers.

Load Capacity and Use

• Maximum load: 25 kg per shelf, evenly distributed. Avoid point loads and loads on the front edge.
• Place heavy objects close to the brackets and toward the back.
• Do not climb onto, sit on, or pull yourself up on the wall shelf; do not hold onto the shelf.
• Do not hang any objects under the shelf unless approved by the manufacturer.
• Position items so that they do not protrude over the edge and cannot fall off.
• Select the mounting height so that head injuries from corners and edges are avoided (take clearance areas into account).
• Check the fastenings regularly; if they become loose, or if the wall shows signs of deformation or cracks, remove the load immediately.

Cleaning and Care

• Clean with warm water, a mild detergent, and a soft cloth; then wipe dry.
• Do not use cleaners containing chlorine or hydrochloric acid, steel wool, or abrasive cleaners: AISI 201 is less resistant to chlorides than AISI 304 and may develop surface rust or pitting corrosion.
• If the surface comes into contact with salt, acids (vinegar, citrus), or cleaning residue, rinse it off promptly and dry it.
• Remove surface rust caused by foreign particles using a stainless steel cleaner.

Disposal

• Dispose of packaging by separating materials.
• Stainless steel is fully recyclable; dispose of old appliances as scrap metal or at a recycling center.